Left Panel - Sony F23 Operation Manual

Left panel

a Level vial
b L handle
c Accessory pockets
d DC IN connector
a Level vial
Used as a reference to check that the camera stands
horizontally. It can be fine-adjusted when required.
If fine-adjustment is required, remove the cover and adjust
it by rotating the three slotted-head screws.
b L handle
The L handle is attached to the top of the camera head at
the factory.
It has three screw holes (
side. The assistant panel (page 16) can be mounted on the
outside of the handle by attaching the supplied assistant
panel hanger.
c Accessory pockets
Using these accessory pockets in combination with the
accessory receptacles (page 11) on the front panel, you can
fix a certain accessory to the left side of the camera.
12
Locations and Functions of Parts
GENLOCK IN
TEST OUT
MONITOR HD
SDI 1
MONITOR HD
SDI 2
DC IN
3
/ ") for accessories on the upper
8
12V EXT I/O 12V 4A 24V 5.5A
OFF
CA ON
DC OUT
24V
j DC OUT 24V connector
i DC OUT 12V connector
h
(network) connector
g EXT I/O connector
f CAM POWER switch
e Power indicators
d DC IN connector (LEMO 8-pin)
Power is supplied by using a specified power cord.
e Power indicators
Either of the indicators lights according to the voltage of
the power being supplied.
f CAM POWER switch
CA: The camera is turned on using the power being
supplied via the interface box (page 16) or CA-F101
(page 21) mounted on the rear.
Note that power is not supplied to an SRW-1
simultaneously mounted on the top via the interface
box mounted on the rear. To supply power to the SRW-
1, use power supply via the DC IN connector (LEMO
8-pin) of the camera head.
OFF: The power is cut off.
ON: The camera is turned on using the power being
supplied from the DC IN connector (LEMO 8-pin) of
the camera head.
Note
If you move the switch setting from ON to CA in one
stroke, the power may not be cut off. To turn off the power,
be sure to set the switch to the OFF position.
g EXT I/O (external control) connector (5-pin)
For control via RS-232C.
k Measure hook/focus
reference mark