Sony F23 Operation Manual page 103

Settings on the MSU-900/950
Set the unit to Engineer mode and set the communication
parameters, using the Ethernet Configuration menu.
Menu Item
Connection Mode selection
Target IP SET
Master IP SET
Master/Client
selection
MSU No.
Negotiation Negotiation
Speed
Duplex
IP Address IP Address
Setting
Net Mask
Gateway
Address
Notes on Ethernet connection
• For stable operations of the connected devices, use the
system in a local network, without connecting to the
Internet.
• Do not connect any device to the local network other
than the system units for this camera.
Recommended remote control devices for
which operation tests have been made
Sony made
• MSU-900/950
• RM-B750
Equipment from other vendors
HUB CentreCOM FS909M-PS
Setting in Bridge mode
Bridge
IP addresses of the connected
cameras
No setting required
No setting required
No setting required
AUTO or OFF
No setting required if Negotiation
is AUTO.
For the OFF setting, select 10M or
100M.
No setting required if Negotiation
is AUTO.
For the OFF setting, select HALF
or FULL.
IP address specific to the MSU
Value corresponding to the
network environments in use
Value corresponding to the
network environments in use
For details on operations, refer to the Operation Manual of
the MSU-900/950.
Setting in Multi mode
Master unit
MCS
No setting required
Client
1
T
T
T
T
T
T
Subordinate unit(s)
IP address of the master
unit
T
2
T
T
T
T
T
T
103
Using the MSU-900/950