Maintenance And Troubleshooting; Heart Rate Monitor Troubleshooting; How To Calibrate The Ramp; How To Adjust The Reed Switch - NordicTrack E 11.6 NTEVEL99813.0 User Manual

Table of Contents

Advertisement

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.

HEART RATE MONITOR TROUBLESHOOTING

If the console does not turn on, make sure that the
power cord is fully plugged in. If lines appear in the
console display, see HOW TO CHANGE CONSOLE
SETTINGS on page 28 and adjust the contrast level
of the display.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 23.

HOW TO CALIBRATE THE RAMP

If the ramp is not functioning properly, the ramp may
need to be calibrated. To calibrate the ramp, press
and hold the Calorie button for several seconds until
the test mode appears in the display.
Press the Calorie button again. Press the 1 Step
Ramp increase or decrease button to calibrate the
ramp. The ramp will move upward and downward as it
calibrates.
When the ramp stops moving, the ramp is calibrated.
Then, press the Calorie button repeatedly to exit the
test mode.
HOW TO GREASE THE RAMP ROLLERS
See the EXPLODED DRAWING near the end of this
manual. If the Ramp Rollers (92) squeak when mov-
ing on the Ramp (43), apply a small amount of the
included PTFE grease to a paper towel. Spread a thin
layer of grease evenly along the tracks. Then, wipe off
any excess grease.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the
reed switch,
first unplug the
power cord.
Using a flat
screwdriver,
release the tabs
on the Top Cover
(20) and pry
the Top Cover
upward off the
elliptical.
Next, look into the access opening and locate the
Reed Switch (69). Rotate the Large Pulley (74) until a
Magnet (75) is aligned with the Reed Switch.
75
93
69
29
20
74

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents