Using The Ir Blaster - Panasonic viera SC-HTB690 Operating Instructions Manual

Using the IR Blaster

With the IR Blaster connection, it is possible to
send the IR signal received by this system's
remote control signal sensor to the TV's sensor.
Use the TV's remote control within the
operation range of this system's remote
control signal sensor.
≥ For the operation range, refer to page 8.
≥ Do not use any other IR Blaster except the
supplied one.
1 Connect the jack plug to the main
unit's Ir SYSTEM terminal.
A IR Blaster (supplied)
2 Place the infrared emitter in sight of
the TV's remote control signal sensor.
Placement example
On the rear of the main unit:
B TV remote control signal sensor
C Infrared emitter
D Adhesive tape
3 Aim the TV's remote control at this
system's remote control sensor and
operate the TV.
≥ When the TV receives signals from both its
remote control and the IR Blaster, their signals
may interfere with each other, making it
impossible for you to operate the TV.
≥ For the location of the TV's remote control signal sensor,
refer to the operating instructions for the TV.
≥ Select a location that suits the environment.
≥ Make sure to clean the surface, where the adhesive tape
is to be attached.
≥ If you peel off the adhesive tape, the surface may
become damaged and exposed adhesive may remain.
Once you have confirmed the TV is operating correctly,
secure it by attaching the adhesive tape.
11
SQT0852