NextBase NBDVR101 Instruction Manual page 24

TROUBLE SHOOTING (CONTD)
PROBLEM
The AV Out from my iN-CAR
CAM just buzzes on my TV.
I get the message "SD Card
Error" on screen.
I get the message "Memory
Error" on screen.
My iN-CAR CAM shuts down
by itself after a while.
The SD card in my iN-CAR CAM
can not be read.
The screen blanks after a few
minutes upon my iN-CAR CAM.
I get the message "Cluster
Wrong" on screen.
I cannot insert the MicroSD card.
I cannot release the MicroSD
card.
Unresolved issues.
Ensure that the AV cable is correct. Use a stereo 2.5mm jack
plug where the tip is the video and the ring is the audio signal.
The SD card has become unuseable by the iN-CAR CAM.
Remove useful files using your PC and then perform a
"FORMAT" upon the SD card from within the SETUP menu.
The SD card has become unuseable by the iN-CAR CAM.
Remove useful files using your PC and then perform a
"FORMAT" upon the SD card from within the SETUP menu.
Check the supplied car adaptor is functioning correctly.
If the iN-CAR CAM is being powered from the battery then
connect power source. i.e. the car adaptor or USB cable.
Use a good quality branded SD card between 4GB and 32GB
(suggested) and format the card from with in the SETUP
menu of the iN-CAR CAM.
The screen saver is set to ON. Change settings to OFF if
required.
Default setting is off.
The SD card has been formatted in another device and the
Cluster Size is not compatible. Simply use the MENU, SETUP
option to re-format the SD card from within the iN-CAR CAM.
Align the SD card with the contacts towards the rear screen of
the iN-CAR CAM.
Push the SD card down until it clicks in place.
Use the edge of a small coin if finger pressure is not sufficient.
Push the SD card down until it clicks to release it.
Use the edge of a small coin if finger pressure is not sufficient.
Reset the iN-CAR CAM to the default settings within the Setup
Menu and try again.
Should the problem persist call the helpline (02920) 866429
or email: support@nextbase.co.uk
24
SOLUTION