Installation Notes - NextBase NBDVR101 Instruction Manual

INSTALLATION NOTES

Please read and follow the notes below for safe operation of your iN-CAR CAM within your vehicle.
As per the supplied installation instructions, it is advised to install the iN-CAR CAM so it does NOT
obstruct the drivers view of the road, preferably on the passenger side of the vehicle and behind the
rear view mirror. Whilst the iN-CAR CAM clearly needs to view through the windscreen in an area
swept by the windscreen wipers, the iN-CAR CAM should be installed so as not to intrude significantly
within the wiped area. A 40mm intrusion into the wiped area is the maximum recommended.
Do NOT mount the iN-CAR CAM in front of the driver, as depicted by the red area in the above
illustration.
When installing the iN-CAR CAM in a vehicle, always place the device securely against the windscreen
and where possible conceal the power cable under trim. Make sure that the iN-CAR CAM power cable
does not interfere with the drivers operating controls, such as the steering wheel, pedals or gear levers.
Do NOT mount the iN-CAR CAM in front of an airbag field of deployment or in a position to obscure any
mirrors.
Clean the windscreen at the point of location, prior to fitting the iN-CAR CAM, also, applying some
moisture to the suction cup may be beneficial, to ensure absolute adhesion.
Do NOT to operate the iN-CAR CAM whilst driving. The automatic Start-Stop technology incorporated
within the device negates any need to operate the controls whilst driving.
Adjust any settings or review recordings whilst stationery, not whilst driving.
After the preliminary SETUP has been carried out upon the iN-CAR CAM, adjust the Screen Saver
setting to 10 Seconds, this will blank the screen automatically shortly after starting the vehicle and the
screen will NOT be a distraction in any way to the driver.
12