ProForm 590 E User Manual page 11

12. Attach the Water Bottle Holder (37) to the
Upright (4) with two M4 x 16mm Screws (104).
13. While a second person holds the Console (7)
near the Upright (4), connect the console wire
to the Wire Harness (111). Then, connect the
console pulse wires to the Pulse Wires (63).
Insert the excess wire downward into the
Upright (4).
Tip: Avoid pinching the wires. Attach the
Console (7) to the Upright (4) with four M4 x
16mm Screws (104).
See step 3. Tighten the M8 x 19mm Patch
Screws (82).
14. Plug the Power Adapter (112) into the DC Jack
(not shown) on the front of the elliptical exerciser.
To plug the Power Adapter (112) into an outlet,
see HOW TO PLUG IN THE POWER
ADAPTER on page 12.
15. Make sure that all parts are properly tightened before you use the elliptical exerciser. Note: After assem-
bly is completed, some extra parts may be left over. Place a mat beneath the elliptical exerciser to protect the
floor.
12
4
104
37
13
Pulse
Wires
63
14
11
104
7
Avoid pinching
the wires
Console Wire
111
4
104
112