Table of Contents
Advertisement
Troubleshooting
Troubleshooting guide
LED indicators on the front panel
The front panel indicators of this unit light up or
flash in order to show the unit's condition. Refer to
the table below to identify the condition.
INFO
LED indicators
When this unit is in
A software (firmware)
standby mode
update is in progress.
"INFO2", (Í/I) light
Never disconnect the AC
up.
mains lead until "INFO2"
and (Í/I) go off. Doing so
may cause malfunctions.
(
72
SQT0993
REC
INFO
REC
Check the following
66)
LED indicators
"INFO1", "INFO2",
The HOLD function is
"REC" flash for
activated. (
5 seconds.
"INFO1" flashes
The remote control does
6 times, "INFO2"
not work. (
goes off.
"INFO1", "REC"
The USB device is drawing
light up, "INFO2"
too much power. Remove
flashes fast.
the USB device.
"INFO1", "REC"
The unit is hot.
light up, "INFO2"
The unit switches to
goes off.
standby for safety
reasons. Wait for about
30 minutes until the
indicators go off.
Install or place this unit
with good ventilation.
"INFO1", "REC"
An abnormality has been
light up, "INFO2"
detected in the power
flashes.
supply to the antenna.
Check to see if the core
wires and braided wire are
in contact with each other
within the antenna cable.
"INFO1", "INFO2"
HDMI cannot be output
light up, "REC"
because it is connected to
goes off.
a model that does not
support copyright
protection.
"INFO1" lights up,
A malfunction has
"REC" flashes.
occurred. The unit is trying
to restore to the normal
operation. Once the
indicators go off you can
use the unit again.
If it remains stays on,
consult the dealer.
"INFO1", "INFO2"
The unit fails to operate
light up, "REC"
properly. Press [Í/I] on the
flashes.
main unit to switch the unit
to standby mode. Now press
[Í/I] on the main unit again
to turn the unit on.
Check the following
67)
65)
Hide quick links:
Advertisement
Table of Contents
