Panasonic DMR-HWT250 Operating Instructions Manual page 70

Troubleshooting
Troubleshooting guide
The timer recording programmed via Network
Service does not work properly.
• Timer recording programmed via Network
Service will be recorded with the same
conditions as those of manual timer recording,
and some functions such as "Guide Link" (
does not work.
Auto Renewal Recording does not work
properly.
• The programme will not be overwritten in the
following cases:
- the programme is protected
- any programme is being played back or copied
- a screen such as Video Menu is displayed
Instead, the programme will be saved as a
separate programme and that will be
overwritten.
A part or whole of a recorded title has been lost.
If there is a power failure or the AC mains lead is
disconnected from the household mains socket
while recording or editing, the title may be lost or
the HDD may become unusable. We cannot offer
any guarantee regarding lost programmes.
Play
You have forgotten your rating PIN number for
parental control.
• The PIN number for parental control and the
rating level return to the factory preset.
The default PIN number is "0000".
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• The "INFO1" indicator on the unit will flash.
2 Press [1] repeatedly until the "INFO2"
indicator on this unit starts flashing.
3 Press [OK].
Image for the Quick View is not smooth.
• Image may not be played back smoothly in case
of high definition titles.
70
SQT0993
Edit
Cannot edit.
• You may not be able to edit on the HDD if there
is no available space. Delete any unwanted
27)
titles to create empty space. (
Photo
Photos do not play back normally.
• The images that were edited on the PC, such as
Progressive JPEG, etc., may not play back.
( 7)
USB
This unit does not recognize the USB device
correctly.
• If inserted during playback the USB device may
not be recognized by this unit.
Disconnect and reconnect the USB device. If it
still does not recognize the connection, switch
the unit to standby mode and turn it on again.
• USB devices connected using a USB extension
cable other than a dedicated one or a USB hub
may not be recognized by this unit.
TV Guide
The TV Guide information is not displayed
properly.
• Set the clock correctly. (
• There was a programme change, or TV Guide
information from a broadcast station was
possibly not correctly transmitted.
• If signal quality is bad, the TV Guide may not be
able to receive any data.
• It may take time until the TV Guide screen is
displayed correctly. Wait for about a day.
Broadcast
Picture regularly breaks up on some
channels.
• Adjust the reception with "Manual Tuning".
( 58)
37)
65, Clock)