Magellan Trailblazer XL Reference Manual page 20

NEAREST (nearest to furthest from your present location). This selection will not affect
the landmark search display. The default sort is ALPHABETICAL.
UTM Grid Plot. This feature adds a UTM grid overlay to the Plotter screen when UTM
coordinates have been selected for the Location 1 screen. Select "ON" or "OFF." The
default is OFF.
Landmark Projection. In the Setup menu, Landmark Projection specifies the tech-
nique used to estimate the coordinates of an unknown location, based on the coordi-
nates of a stored landmark.
Select:
LMK PROJECT
MAP PROJECT
TRIANGULATION
Map Scale. Map Scale allows you to enter the scale used by your map and select a
convenient unit of measure (inches or centimeters). The selections you make here
affect the Map Project feature of Landmark Project. The default setting is 1:24,000.
Since Map Project uses measurements taken from your map to estimate coordinates
for an unknown location, the scale entered here must match the scale used by your
map. Which scale your map uses can be found in the legend.
Highlight "MAP SCALE" and press ENTER.
Key in the scale of your map. The scale will be
"1:" and some number. Key in the number
and press ENTER.
Use the RIGHT/LEFT ARROW to select
"INCHES" or "CM." (Use the units you are
most comfortable with.) Press ENTER.
Alarm. Your Magellan receiver has the ability to
sound an external alarm when you arrive at your
destination (ARRIVAL); have moved a predefined dis-
tance from the place where you set your anchor (AN-
CHOR); and/or if your cross track error is greater then
Using Your Magellan Receiver
to project coordinates using bearing and distance. (Default)
to project coordinates on a map using inches or centimeters N
or S and E or W. (The unit used is selected in Map Scale.)
to project coordinates using bearing from two landmarks.
11