Magellan Trailblazer XL Reference Manual page 16

The following sample uses the coordinates for Los Angeles, California (34.03N lati-
tude and 118.14W longitude). Do not use these coordinates unless you are within
300 miles of Los Angeles. Use the coordinates for a City within 300 miles of your
location.
Highlight "INITIALIZE" and press ENTER. The
first character of latitude is highlighted. This
is the cursor. Press the UP/DOWN ARROW
to select the first character. When the desired
number is displayed, press the RIGHT ARROW
to move the cursor to the next space.
Your display should be similar to the one
shown here. Remember that the UP/
DOWN ARROW steps up or down through
the list of characters, and the RIGHT/LEFT
ARROW moves the cursor to the right or
left.
Continue entering the latitude. When it
matches the latitude you found in the City
Reference Chart, press the RIGHT ARROW
to move the cursor over the hemisphere, then
use the UP/DOWN ARROW to select "N" or
"S." Once the latitude and hemisphere are
correct, press ENTER.
The cursor jumps down to the next line. Fol-
low the same procedure to enter the longi-
tude and select "E" or "W." Press ENTER. (If
you notice a mistake, it can be corrected on
the current line before ENTER is pressed; if
the mistake is on the previous line or if ENTER
has been pressed, press SETUP, select INITIAL-
IZE, and start over.)
Using Your Magellan Receiver
7