Magellan Trailblazer XL Reference Manual page 17

The receiver now prompts you for the eleva-
tion. You do not have to enter this informa-
tion right now. Press ENTER to use the de-
fault elevation of 0 feet.
Key in your local time in a 12-hour (AM/PM) clock. Take extra care to enter the
ti me correctly, including the AM/PM designation. Entry is the same as for lati-
tude and longitude. Once the correct time is displayed, press ENTER.
The last bit of information the receiver needs
is the date. Use the UP/DOWN ARROWs to
key in the current date. (Your display should
resemble the one shown.) If everything is cor-
rect, press ENTER. If there is a mistake, press
SETUP, LEFT ARROW, ENTER, and rekey the
information.
You should not have to re-enter an initial position unless you clear the receiver's memory
or move the receiver more than 300 miles from its last location while it is off.
Coordinate System. This feature allows you to select the coordinate system that you
will use to enter and view location information. The system you select will depend an
the maps or charts that you are using with your receiver.
The most commonly used system is Lat/Lon, which uses the imaginary lines of latitude
and longitude. Other coordinate systems used by the Trailblazer XL are UTM and OSGB.
You may also enter any grid system manually. These systems are described in
Chapter 4.
Trailblazer XL has two location coordinate screens: Location 1 and Location 2. You
may select a different coordinate system for each display.
8 Using Your Magellan Receiver