Mitsubishi HS-U430 Owner's Manual page 47

CH DAY ON OFF
2 MOI2 ll:30a I:30pSP
i0 TH20 9:00pIO:OOpEP
....... : .... :-- SP
: : SP
Recap screen
O Use the MENU button to turn off the menus. Then, use the
POWER button to turn off the VCR. Make sure the pro-
grammed recording light is on.
canceling a programmed recording beforethe recording starts
O
Press the MENU button on the remote c_ntrol. Your VCR will
turn on and the "VCR Main Menu" will appear on your
screen. Use the ADJUST buttons on tile remote control to
select "Program to record." Press the ENTER button.
You will see the "recap" _,.creen. Use the ._kDJUST buttons to
place the cursor next to the program you wish to cancel.
Press the CANCEL button. The program is erased.
0 Press the MENU button once to return to the VCR Main
Menu; press it again to turn off the menus.
usingthe TIMERRESETbutton
You can use the TIMER RESET button on the rear panel to erase
both the time and all programmed recording,;.
To use the TIMER RESET button, press it wlth a pencil or a ball
point pen. The power will tm=a off and the clock will be cleared.
All programmed recording is erased. Howeve r, if you have set the
"Clock set" setting of the "Set the clock" menu to AUTO, the auto
clock function will automatically set the clock again. (See ]?age
3O.)
Additionally, the TIMER RESET button will reset the on-,_creen
language you selected. The next time you use the menus, you will
have to select the on-screen language. (See p_;.ge 25.)
loadinga tapefor programming
If, after programming, you forget to load a tape, or if you load a
tape with its erasure tab removed, then the p::ogrammed record-
ing light and the tape status symbol will flask. A tape without an
erasure tab will be ejected. To correct this, load a tape with its
erasure tab intact, and turn off the VCR.
memorybackup
If the VCR is without power for 30 minutes oz' less, it will retain
the clock and the programmed settings, provided the VCR :has
been plugged in for at least an hour beforehand. If the power is
lost for more than 30 minutes, the clock and tile programmed
settings will be lost. However, if you have set _:he "Clock selL"
setting of the "Set the clock" menu to AUTO, the auto clock
function will automatically set the clock again. (See page 30.)
45