Indicators - Mitsubishi XL1U User Manual

Indicators

The projector has three LED Indicators which shows the working condition of the projector.
The following offers solutions to possible problems. If a problem persists, turn the projector off and consult your
dealer.
POWER indicator
LAMP indicator
TEMP indicator
Normal condition
POWER LAMP TEMP CONDITION
Stand-by
Off Off
Steady
red
Lamp stand-by (about for 1 minute)
Off
Steady Blinking
green green
The POWER is ON. (Normal condition)
Off
Steady Steady
green green
Abnormal condition
POWER LAMP TEMP CONDITION
Unusual temperature
Steady Steady Blinking
• The ventilation slits or air filter is clogged with
green green red
• The room temperature is too high.
• The filter is dirty.
Off
Steady Blinking
red red
The protection circuit is working or the lamp is in an
abnormal condition.
Off
Steady
Blinking
red
green
Lamp duration warning. (Lightning duration total
Off
Steady
Blinking
about 1, 000 hours*.When the POWER is ON.)
green
green/red
Lamp duration warning. (Lightning duration total
Off
Steady Blinking
about 1, 000 hours*.When the POWER is OFF.)
red red
Lamp duration warning. (Lightning duration total
Off
Steady Steady
about 1,500 hours*.)
red red
The lamp cover is not closed.
Off Off
Blinking
green/red
Abnormal.
Steady Steady
or or
Blinking
green/red
Blinking Blinking
*) When LAMP MODE of the INSTALLATION menu is set to STANDARD. When it is set to LOW, the duration will be extended.
VOLUME
LAMP
TEMP
dust or debris.
AUTO
COMPUTER
POSITION
SOURCE
VIDEO
MENU
Notes
The power button cannot be used to switch
ON and OFF
POSSIBLE SOLUTIONS
• Remove the object from the ventilation
slits.
• Relocate the projector to a cooler place.
• Clean the filter.
• Wait until the LAMP indicator is turned
off, then press the POWER button.
• If the above operation is not effective,
replace the lamp.
Replace the lamp.
Exchange with a new lamp if the same
problem recurs.
Close the cover correctly.
Contact your dealer.
MUTE
ENTER
EN – 25