LCD Projector
XL5950U / XL5950LU / XL5900U / XL5900LU
Controling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions :
• Turning the power ON or OFF
• Changing input signals
• Inputting commands by pressing the buttons on the control panel and remote control
• Menu setting
Connection
REMOTE
REMOTE
INPUT 1
R/P
R
IN
OUT
INPUT 2
MAIN
AC IN
Important:
• Make sure that your computer and projector are turned off before connection.
• Turn on the projector after the computer is started up.
(If you do not follow this instruction, the Comport may not function.)
• There are two RS-232C terminals on the projector. You can use either of them.
• Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
1) Interface
PROTOCOL
BAUD RATE
DATA LENGTH
PARITY BIT
STOP BIT
FLOW CONTROL
This projector uses RXD, TXD and GND lines for RS-232C control.
For RS-232C cable,the reverse type cable should be used.
2) Control command diagram
The command consists of the address code, function code, data code, and end code. The length of the command
varies among the functions.
Address code
HEX
30h 30h
ASCII
'0' '0'
[Address code]
30h 30h (In ASCII code, '0' '0') fixed.
[Function code]
A code of each fixed control move.
[Data code]
A code of each fixed control data (number) and not always indicated.
[End code]
0Dh (In ASCII code, '
to RS-232C/MOUSE terminal
or RS-232C terminal
USB
RS-232C
RS-232C/MOUSE
G/Y
B/P
H/H
V
B
V
8P
AUDIO
VIDEO
IN
2
S-VIDEO
Y
VIDEO
1
AUDIO
OUT
C
L
AUDIO
R
RS-232C
9600 [bps]
8 [bits]
NONE
1 [bit]
NONE
Function code
Function
Function
') fixed.
RS-232C cable
D-SUB 9P
Data code
End code
Data
0Dh
Data
1
to SERIAL port