Maintenance Free Battery; How To Install The Battery Cables - Craftsman 536.270321 Operator's Manual

Hide thumbs Also See for 536.270321:
Table of Contents

Advertisement

MAINTENANCE FREE BATTERY

IMPORTANT: Before you attach the battery cables to the
battery, check the battery date. The battery date tells if the
battery must be charged.
1.
Raise the seat support and secure in the UP position with the
seat support rod.
2.
Check the top and the side of the battery for the location of the
battery date (Figure 1).
3.
If the battery is put into service before the battery date, the
battery cables can be attached without charging the battery.
See "How To Install The Battery Cables".
4.
If the battery is put into service after the battery date, the
battery must be charged. See "How To Charge The
Maintenance Free Battery".
HOW TO CHARGE
THE MAINTENANCE FREE BATTERY
WARNING: When you charge the battery, do not
smoke. Keep the battery away from any sparks. The
fumes from the battery acid can cause an explosion.
1.
To disconnect the battery retainer from the battery tray, push
in on the lower end of the battery retainer.
2.
Remove the battery from the right side of the unit.
400150
PREPARATION
3.
4.
5.

HOW TO INSTALL THE BATTERY CABLES

Use the fasteners shown below to install the battery cables. The
fasteners are shown at full size.
1.
2.
3.
Battery
A
Positive (+)
Terminal
A
Terminal
Cover
Battery Clamp
8
Remove the protective cap from the battery terminal.
Use a 12 volt battery charger to charge the battery. Charge at
a rate of 6 amperes for one hour. If you do not have a battery
charger, have a Sears or other qualified service center charge
the battery.
Install the battery and secure with the battery retainer. Make
sure the positive (+) terminal is on the right side.
WARNING: To prevent sparks, fasten the red cable to
the positive (+) terminal before you connect the black
cable.
(A)
2x82
Remove the protective cap from the battery terminal.
Fasten the red cable and terminal cover to the positive (+)
terminal with the fasteners as shown (Figure 1).
Fasten the black cable to the negative (−) terminal with the
fasteners as shown.
Red Cable
(B)
14x79
Black Cable
B
Figure 1

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents