Lighting Instructions - Lennox NV35IN Care And Operation Instructions Manual

LENNOX HEARTH PRODUCTS • SIGNATURE

LIGHTING INSTRUCTIONS

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY,
A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
A. When lighting the appliance, follow these instructions exactly.
B. BEFORE OPERATING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone.
• If your gas supplier cannot be reached, call the
fire department.
1. STOP! Read the safety information above on this page.
2. Turn remote wall switch to OFF or set wall thermostat to
lowest setting. If used, remove the batteries from the battery
holder.
3. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
4. Push the unit mounted ON/OFF switch to the OFF position.
5. Allow sufficient length of time (minimum 5 minutes) for any
gas in the combustion chamber to escape. If you still smell
gas, STOP! Follow Step B in the safety information above on
this page. If you do not smell gas, go to the next step.
1. For complete shutdown, turn remote wall switch to OFF or set
the thermostat to the lowest setting, if applicable.
2. Turn the ON/OFF switch to OFF. If Step 1 is not applicable.
SERIES DIRECT-VENT GAS FIREPLACES • ENVY/ENVY CD 35/40/45 • CARE AND OPERATIONS
®
FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
On
Remote
Off
PRG
TO TURN OFF GAS TO APPLIANCE
DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
C. Use only your hand to turn the gas control lever. Never use
tools. If the lever will not turn by hand, do not try to repair
it, call a qualified service technician. Force or attempted
repair may result in a fire or an explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
6. Push the unit mounted ON/OFF switch back to the ON
position. The ON/OFF switch may include a wall switch if
so equipped. Replace the batteries in the battery holder, if
used. If the burner does not light or stay lit after several
tries, turn the unit mounted ON/OFF switch to the OFF
position and call your service technician or gas supplier.
NOTE: Sufficient time must be allowed for air to escape
from lines if the unit is being lit for the first time.
7. Turn HI/LO burner control knob to desired setting and close
control door.
8. Set thermostat to desired setting, if applicable.
9. If the appliance will not operate, follow the instructions "To
Turn OFF Gas To Appliance" and call your service technician
or gas supplier.
To Shut OFF
1. Turn OFF all electrical power to the appliance (remote
wall switch) or set the thermostat to the lowest setting, if
applicable. Or remove batteries, if used.
3. Turn off all electric power to the appliance and remove
backup batteries if service is to be performed or for
extended shutdown.
17