Bissell PROHEAT 2X LIFT-OFF 30K7 Series User Manual page 11

Maintenance:
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
1
To clean machine before
storing it, fill the Formula
& Water Tank with hot tap
water only, in order to flush
out any residual formula
2
Spray Tips
Screw 1
Two Covers
Separate the Pod from
the base, remove the two
Spray Tips, rinse at a
faucet and replace
3
Wipe out the end caps with a
clean paper towel
Cleaning Machine After Use
Turn unit on, press and
hold the trigger for
15 seconds while making
back and forth passes
Screw 2
Spray Tips
Spray Tip
Screw 3
Unscrew three screws with
a Phillips screwdriver from
the clear Brush Rolls covers
Rinse and replace clear Brush Covers,
carefully aligning top cover tabs along
front slots of bottom cover
Release trigger and
suction up all of the water
Before replacing clear
cover, inspect the
Brush Rolls and remove
any debris
Pivot into place
www.BISSELL.com
Insert Tabs
into slots
11