Measuring At One Listening Position (Single Measure) - Yamaha CX-A5100 Owner's Manual

1 2 3 4 5 6 7 8 9 10 11 12
SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7
V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
TUNER TUNER BLUETOOTH BLUETOOTH USB USB NET NET
PHONO PHONO MULTI MULTI [ A ] [ A ] [ B ] [ B ]
SCENE SCENE
1 1 2 2 3 3 4 4
PROGRAM PROGRAM MUTE MUTE VOLUME VOLUME
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON SCREEN ON SCREEN OPTION OPTION
Cursor keys
ENTER
ENTER
RETURN
RETURN DISPLAY DISPLAY
MODE MODE
LIVE LIVE
CLASSICAL CLASSICAL CLASSICAL ENTERTAIN ENTERTAI T T N
CLUB CLUB
PRESET PRESET
MOVIE MOVIE STEREO STEREO STRAIGHT STRAIGHT
TV TV
PURE PURE
INPUT INPUT
DIRECT DIRECT
TV VOL TV VOL TV CH TV CH
MUTE MUTE
Measuring at one listening position
(single measure)
When "Multi Position" is set to "No", follow the procedure below for
measurement. It takes about 5 minutes to perform the
measurement.
• If any error message (such as E-1) or warning message (such as W-1) appears,
see "Error messages" (p.55) or "Warning messages" (p.56).
• Do not use the microphone base until the corresponding message appear on the
TV.
1
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement finishes.
(When angle/height measurement is disabled)
Proceed to Step 3.
(When angle/height measurement is enabled)
Proceed to Step 2.
2
Perform the angle/height measurement.
a Use the cursor keys to select "YES" and press ENTER.
Select "NO" to cancel the angle/height measurement.
b Attach the supplied pole to the center of the microphone base.
48
En
Pole
Microphone base