Single Analog Antenna; Separate Uhf And Vhf Antennas; Single Analog Antenna Or Separate Uhf And Vhf Antennas - Mitsubishi Electric WS-55517 Owner's Manual

Connecting a Single Analog Antenna or Separate UHF and
VHF Antennas
Single Antenna
(not for use with CableCARD™)
Figure 3
A 300-Ohm to 75-Ohm transformer is required. This is not
included with the TV.
For antennas with twin flat lead
1. For antenna with twin flat leads, connect the
300-Ohm twin leads to the 300-Ohm to 75-Ohm
transformer.
2. Push the 75-Ohm side of the transformer onto ANT-1
MAIN on the TV back panel.
For antennas with coaxial lead
3. Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
300-Ohm
75-Ohm
FlatTwin
Coaxial
Lead
Cable
3.
2.
1.
TV back panel (section detail)
Optional 300-Ohm
to 75-Ohm
Matching Transformer
Figure 3. Connecting an Antenna
16
ANT-2 ANT- T T 2 ANT-1
AUX AUX MAIN
DIGITAL DIGITA T T L
E1394 E1394
AUDIO AUDIO
OUTPUT OUTPUT
CableCARD CableCARD TM TM SLOT SLOT
– (DTV/CABLE /VHF/UHF) –
Mitsubishi strongly recommends against using
antennas with twin flat leads. Twin flat lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.

Separate UHF and VHF Antennas

Figure 4
A UHF/VHF combiner is required. This is not included with
the TV.
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto ANT-1 MAIN on the TV
back panel.
UHF Antenna
VHF Antenna
(Channels 14-69)
(Channels 2-13)
Flat Twin Lead
Flat Twin Lead
External
Antenna
or Cable
TV back panel (section detail)
300 Ohm to
75 Ohm
Combiner
UHF
2.
VHF
Back Side
1.
Figure 4. Connecting separate UHF and VHF Antennas
ANT- T T 2 ANT-2 ANT-1
AUX AUX MAIN
DIGITAL DIGITA T T L
SERVICE SERVICE
IEEE1394 IEEE1394
AUDIO AUDIO
PORT PORT INPUT/OUTPUT INPUT/ T T OUTPUT
CableCARD SLOT CableCARD SLOT
– (DTV/CABLE /VHF/UHF) –