Vcr Setup; Cable Tv Setup - Mitsubishi PD-4225S Owner's Manual

NOTE: Not all cables shown are included with the TV. They are available at most consumer electronics stores.

VCR Setup

VCR Setup
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Use the Long Life feature to avoid having a fixed image remain on the screen for a long period of time, i.e. a frozen still picture
from a VCR. If the 4:3 picture format is used, the fixed image may remain visible on the screen and create permanent phosphor
burn-in. Read Page 7 for more information regarding Uneven Phosphor Aging.
Connection 1
Set VCR switch to 3 or 4 and then tune TV to the same
channel number.
Connection 2
1. Connect the audio and video cables from the VCR's output
jacks to the TV input jacks, as shown in the figure.
When connecting the TV to VCR, match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
2. Insert a video tape into the VCR and press PLAY on the VCR.
(Refer to the VCR owner's manual.)
3. Use the DEVICE button on the remote control to select
Video (Rear).
Cable TV Setup
Cable TV Setup
- After subscribing to a cable TV service from a local provider and installing a converter, you can watch cable TV programming.
- For further information regarding cable TV service, contact your local cable TV service provider(s).
Connection 1
1. Select 3 or 4 with channel switch on cable
box.
2. Tune the TV channel to the same selected
output channel of cable box.
3. Select channels at the cable box or with the
cable box remote control.
Connection 2
1. Connect the audio and video cables from the
cable box output jacks to the TV input jacks,
as shown in the figure.
When connecting the TV to cable box, match
the jack colors (Video = yellow, Audio Left =
white, and Audio Right = red).
2. Use the DEVICE button on the remote con-
trol to select Video (Rear).
3. Select channels with the cable box remote
control.
24 Plasma TV
1
1
2
or
Cable Box
2
VCR