Table of Contents
Advertisement
Available languages
Available languages
mate, wood preservative). Material containing
asbestos must only be treated by specialists.
- Where the use of a dust extraction device is
possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
Materials that generate dusts or vapours that may
be harmful to health must not be processed.
Wear ear protectors. Exposure to noise can cause
hearing loss.
Wear protective gloves.
Always wear protective goggles.
Secure the workpiece against slipping, e.g. with
the help of clamping devices.
Always guide the machine with both hands on the
handles provided. Loss of control can cause
personal injury.
Never place your hand near rotating parts of the
device or near the rotating sanding belt.
Remove sanding dust and similar material only
when the machine is not in operation.
Pull the plug out of the plug socket before any
adjustments, conversions or servicing are
performed.
The rated speed of the sanding belt must be at
least equal to the belt speed in idling marked on
the power tool. A sanding belt running faster than
its rated speed can break and fly apart.
Check prior to each use that the sanding belt is
correctly attached and is completely on the rollers.
Carry out a trial run: Allow the machine to run at
idling speed for 30 seconds in a safe location. Stop
immediately if significant vibrations occur or if
other defects are noted. If such a situation occurs,
check the machine to determine the cause.
SYMBOLS ON THE TOOL:
........Class II Construction
V............volts
A............amperes
Hz..........hertz
~
...........alternating current
n
..........no load speed
0
../min ....revolutions per minute
rpm ......revolutions per minute
B
..........sanding belt length
L
4 Overview
See page 3 (please unfold).
1 Sliding switch
2 Adjusting wheel for setting belt speed
3 Electronic signal indicator
4 Additional handle
5 Tensioner arm for replacing the sanding belt
6 Sanding belt
7 Arrow (direction of rotation of drive shaft)
5 Scope of delivery
The machine is also available with different acces-
sory parts. An overview can be found on page 4.
Subject to change.
A Sanding belt, zirconia alumina
B Nylon web band
C Felt band
D Metabo Pyramid sanding belt
E Polishing paste
F Microfibre cloth
G Stainless steel cleaning spray
6 Initial Operation
Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the rating label, match with your power
supply.
Attaching the additional handle
Always work with the additional handle
attached (4)! Secure the additional handle by
screwing it tightly to the left or right.
7 Use
7.1
On/Off switch, continuous activation
Always guide the machine with both hands.
The machine must not be allowed to draw in
additional dust and shavings. When
switching the machine on and off, keep it away
from dust deposits.
After switching off the machine, only place it
down when the motor has come to a stand-
still.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine using
the handles provided, stand in a safe position and
concentrate.
ENGLISH
ENG
7
Advertisement
Table of Contents
