The Static Dhcp Screen - ZyXEL Communications LTE7410 User Manual

Table 7 Network Setting > Home Networking > IPv6 LAN Setup (continued)
LABEL
Other config flag
on
Advertisement
interval option on
Hop limit
Router Lifetime
Router Preference
Reachable Time (ms)
Retrans Timer (ms)
RA Interval
Delegate MTU from
WAN
Manual
MTU
DAD attempts
Apply
Cancel
Advanced Setup

5.4 The Static DHCP Screen

This table allows you to assign IP addresses on the LAN to specific individual computers based on
their MAC Addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is
assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02.
Chapter 5 Home Networking
DESCRIPTION
Select this to have the LTE Device indicate to hosts to obtain DNS information through
DHCPv6.
Clear this to have the LTE Device indicate to hosts that DNS information is not
available in this network.
Select this to have the Router Advertisement messages the LTE Device sends specify
the allowed interval between Router Advertisement messages.
Enter the maximum number of network segments that a packet can cross before
reaching the destination. When forwarding an IPv6 packet, IPv6 routers are required
to decrease the hop limit by 1 and to discard the IPv6 packet when the Hop Limit is 0.
Possible values for this field are 0-255.
Enter the time in seconds that hosts should consider the LTE Device to be the default
router. Possible values for this field are 0-9000.
Select the router preference (Low, Medium or High) for the LTE Device. The LTE
Device sends this preference in the router advertisements to tell hosts what
preference they should use for the LTE Device. This helps hosts to choose their default
router especially when there are multiple IPv6 routers in the network.
Note: Make sure the hosts also support router preference to make this function work.
Enter the time in milliseconds that can elapse before a neighbor is detected. Possible
values for this field are 0-3600000.
Enter the time in milliseconds between neighbor solicitation packet retransmissions.
Possible values for this field are 1000-4294967295.
Enter the time in seconds between router advertisement messages. Possible values for
this field are 4-1800.
Select this to have the LTE Device obtain the MTU setting from the service provider or
uplink router.
Select this to specify the MTU manually.
The Maximum Transmission Unit. Type the maximum size of each IPv6 data packet, in
bytes, that can move through this interface. If a larger packet arrives, the LTE Device
divides it into smaller fragments.
Specify the number of DAD (Duplicate Address Detection) attempts before an IPv6
address is assigned to the LTE Device LAN interface. Possible values for this field are
1-7.
Click this to save your changes.
Click this to restore your previously saved settings.
Click this to close the IPv6 LAN Setup Advanced Setup section.
LTE7410 User's Guide
37