Continuous Water Drainage - Prem-I-Air PDEH2020 User Manual

Drainage Procedures
1. Take out the water tank.
At the top of the water tank gently
press the two sides inwards
2. Hold the handle, and pull out the water
tank.
(Insert diagr
3. Empty the water from the tank.

CONTINUOUS WATER DRAINAGE

This unit is equipped with a water outlet for continuous drainage. Use a water tube (size 15mm). Always
unplug the unit before attempting to install a drain.
1. Take off the water tank, and open the
water outlet for Continuous drainage.
Use a pair of pincers or a similar tool to
cut open the water outlet located at the
side of the unit.
2. Insert the drain hose into the water outlet
opening. Pass the water hose (size
15mm) through the water outlet opening
and firmly push it into the water outlet of
the main unit. Do not block the hose.
Attention
Do not remove the float or sensor in the water tank,
because the float and the sensor are used to monitor
whether the water tank is full or not. Damage to the
float or the sensor may make the
water in the tank overflow.
If the water tank is dirty, please clean it with cold or
lukewarm water. Do not use any cleaning detergents
sprays or other chemicals, as they will damage the unit
and cause it to leak.
When the water tank is re-installed, push it back to its
original position. The unit will not function when the
tank is incorrectly installed
.
6