Quick Start
To attach the Diamond Pro 750
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information, refer to the display card
manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card
in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the Diamond Pro 750
to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the captive
signal cable to the Diamond Pro 750
(Figure B.1). Tighten all screws.
4. Connect one end of the power cord to the Diamond Pro 750
end to the power outlet (Figure C.1).
5. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
15-pin
mini
D-SUB
Captive Signal Cable
SB
/ Diamond Plus 93
SB
/ Diamond Plus 93
Figure A.1
SB
monitor to your system, follow these instructions:
SB
SB
/ Diamond Plus 93
SB
Macintosh cable adapter on the computer
SB
/ Diamond Plus 93
Figure B.1
Captive Signal Cable
Diamond Pro 750
Macintosh cable adapter (not included)
SB
monitor and the other
Mac Adapter
(Not Included)
SB
/ Diamond Plus 93
SB
5