Grizzly G0690 Owner's Manual page 72

To check/adjust the fence height and square-
ness to the table:
1.
DISCONNECT THE SAW FROM POWER!
2.
Place a square on the table against the face
of the fence (Figure 116) to check if the fence
is square to the table.
— If the fence is not square to the table, pro-
ceed to Step 3.
— If the fence is square to the table, skip
ahead to Step 4.
90° Square
Figure 116. Checking if fence is square to table.
3. Adjust the set screws (Figure 117) on top of
the fence bracket to ensure the fence face is
90° to the table, then tighten the knurled lock
nuts.
Set Screws
Lock Nut
Figure 117. Fence components used to adjust
fence height and squareness to table.
4.
Look at the gap between the fence and the
table top.
— If the gap is approximately
from the front of the table to the back, then
no additional adjustments are necessary.
-70-
Fence
Table
Rear Rail
Fence Foot
Bracket
⁄ " and even
1
16
—If the gap is uneven, if the fence height is
more than 1 ⁄ ", or if the fence touches the
8
table, then continue with Step 5.
5. Adjust the fence height with the rear rail foot
until the gap between the table and the fence
is approximately ⁄
1
16
of the table to the back.
Note: If the front end of the fence needs to
be adjusted up or down, use the set screws
from Figure 117; however, turn them in
even increments and recheck the square-
ness afterwards.
Clamping Pressure and Parallelism
Set screws on the rear side of the fence bracket
adjust the clamping pressure to hold your fence
securely, and position the fence parallel to the
blade.
To adjust the fence clamping pressure and
parallelism to the blade:
1.
DISCONNECT THE SAW FROM POWER!
2.
Remove the fence.
3.
Equally adjust the set screws shown in
Figure 118 on the rear side of the front
bracket as necessary until the clamping pres-
sure is strong enough that the fence will not
move as pressure is applied against it.
Set Screws
Fence
Bracket
Figure 118. Location of set screws used to
adjust fence parallelism and clamping pressure.
4. Place the fence approximately 4" away from
the blade.
Model G0690/G0691 (Mfd. 6/15+)
" and even from the front