Grizzly G0690 Owner's Manual page 27

10. Install the front rail onto the table and exten-
sion wings with (4) M8-1.25 x 40 hex bolts,
(8) 8mm flat washers, (4) 8mm lock wash-
ers, and (4) M8-1.25 hex nuts, as shown in
Figure 18.
Before final tightening, make sure the front
rail is set ⁄ " below the beveled edge of the
3
16
main table and extension wings along its
entire length.
Figure 18. Front rail installed (Model G0690
shown).
11. G0690 ONLY: Install the 62" front rail rectan-
gular tube onto the 50" front rail with (3) M6-1
x 16 cap screws, 6mm flat washers, and 6mm
lock washers, as shown in Figure 19.
Figure 19. Model G0690 tube attached to front
rail.
Model G0690/G0691 (Mfd. 6/15+)
G0691 ONLY: Install the 82" front rail rectan-
gular tube onto the 70" front rail with (5) M6-1
x 16 cap screws, 6mm lock washers, and
6mm flat washers, as shown in Figure 20.
Figure 20. Model G0691 tube attached to front
12. Attach the rear rail to the holes on the main
table using (2)
lock washers, and 8mm flat washers, as
shown in Figure 21.
x3
Figure 21. Rear rail installed (Model G0691
13. Secure the rear rail to the extension wings
with (2) M8-1.25 x 40 hex bolts, (4) 8mm
flat washers, (2) 8mm lock washers, and (2)
M8-1.25 hex nuts.
rail.
⁄ "-18 x 1" hex bolts, 8mm
5
16
x2
shown).
x5
-25-