Sprocket Cover Wiring - Buell 2004 XB9S Service Manual

HOME

SPROCKET COVER WIRING

GENERAL
Connectors for the stator [46], voltage regulator [77], vehicle
speed sensor [65], cam position sensor [14] and neutral
switch [131] are located under the sprocket cover.
REMOVAL
1. Remove sprocket cover. See
2. See Figure 7-91. Disconnect appropriate connector(s).
INSTALLATION
NOTE
See Figure 7-91. All wiring under sprocket cover that gets
routed from sprocket area towards front of vehicle is routed
behind cam cover breather line (8).
1. Route oil pressure switch wiring (10) from main harness
(6), behind cam cover vent line (8) to oil pressure switch
located on front of engine.
NOTE
Stator connector wiring is installed over oil pressure wiring.
2. Connect stator connector (9).
3. See Figure 7-92. Connect cam position sensor [14] (1).
Form a loop (2) as shown using wiring leading to cam
position sensor.
7-74 2004 Buell Lightning: Electrical
2.31 SPROCKET COVER.
8748d
5
4
3
2
1
11
1. Voltage regulator connector [77]
2. Cam position sensor connector [14]
3. Neutral switch connector [131]
(approximate location)
4. Neutral switch location
5. Cable straps
6. Main harness
7. Vehicle speed sensor connector [65]
8. Cam cover vent line
9. Stator connector [46]
10. Oil pressure switch wiring
11. Interactive exhaust cable (XB12's only)
Figure 7-91. Sprocket Cover Wiring
8717b
3
7
1
1. Cam position sensor [14]
2. Cam position sensor and neutral indicator
switch wiring
3. Neutral switch location
4. Cam cover vent line
5. Stator connector [46]
6. Oil pressure switch wiring
7. Interactive exhaust cable
Figure 7-92. Cam Position Sensor Wiring
7.26
8748b
6
5
7
8
10
9
5
2
4
5
6