Seat - Buell 2004 XB9S Service Manual

HOME

SEAT

GENERAL
See Figure 2-117. The seat anchors in three places on the
vehicle. The first is where the locating tab (4) on the seat
inserts into the opening on the trunk pan (5). The second is
the pair of seats hooks (3) that slide onto the shouldered fas-
teners (6) located in the left and right tail sections. The last is
the rear seat tab (2) which fits into the slot (7) on the seat
latch (8).
REMOVAL
1. See Figure 2-117. Insert ignition key into seat lock
located on left side of motorcycle below seat.
2. Turn key clockwise to disengage rear seat latch.
3. Lift and remove seat (1).
2
1
1. Seat
2. Rear seat tab
3. Seat hooks
4. Locating tab
INSTALLATION
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
1. Install seat (1) by sliding locating tab (4) on front under-
side of seat into opening (5) on trunk pan.
2. Align rear tab (2) with latch slot (7) at rear of motorcycle.
3. Press down firmly on rear of seat to engage seat latch
(8). Pull up on rear of seat to make sure latch is
engaged.
4. Remove ignition key from seat lock.
3
5. Opening in trunk pan for locating tab
6. Shouldered fasteners for seat hooks
7. Slot in seat latch
8. Seat latch
Figure 2-117. Seat and Attachment
11 1
WARNING WARNING
4
6
7
5
2004 Buell Lightning: Chassis
2.41
10049
8
2-93