HOME
SPROCKET COVER WIRING
GENERAL
Connectors for the neutral switch [131] and the oil pressure
indicator switch [120] are located under the sprocket cover.
sm03744c
Figure 6-117. Correct routing of Interactive Exhaust Cable
6-94 2010 XB Service: Electrical
REMOVAL
1.
Remove sprocket cover. See
2.
Disconnect appropriate connector(s).
NOTE
The actuator cable, neutral switch connector and the oil pres-
sure switch wire is located under the sprocket cover.
3.
Route oil pressure switch wiring from main harness, to oil
pressure switch located on the bottom front of the oil pump
body and connect to the oil pressure switch.
4.
Connect the neutral safety switch (single bullet).
5.
See
Figure
6-117. Route the interactive exhaust cable
behind the oil pump body beside the neutral switch con-
nection and the oil pressure switch wire and install a cable
strap.
6.
Install sprocket cover. See
6.29
2.36 SPROCKET
COVER.
2.36 SPROCKET
COVER.