Recording To Ieee 1394 Recordable Devices - Mitsubishi Electric WD-52631 Owner's Manual

82
Chapter 7. Using IEEE 1394 Devices
Recording to IEEE 1394 Recordable
Devices
You can use the TV to control recording to IEEE 1394
devices. While recording, you can view a program on a
different input or power off the TV. The following table
lets you see what signals can be recorded to an IEEE 1394
digital VCR or A/V disc.
Recording
Signal Type
Availability
Can be Digital channels,
recorded including high-defini-
tion channels
Digital signals, includ-
ing high-definition
signals
Cannot be Analog channels
recorded
Analog signals
Digital signals
Summary of signal inputs and recording to an IEEE 1394
digital VCR or A/V disc.
There are two ways to record digital content to an IEEE
1394 recordable A/V disc or DVCR:
• From the TV's Recording Setup menu
• From the TV's ChannelView™ channel guide
Immediate Recording from the Recording
Setup Menu
Recording Now from the Menu
(RECORD) to open the Recording Setup menu.
1. Press
Figure 1. The Recording Setup menu
2. Review the recording setup information. Move the
highlight to each box you need to change.
• With the leftmost icon highlighted (the source),
press to change the source input if needed.
• Channel. If the source is an antenna, select a
memorized digital channel using
enter the channel number from the remote control.
3. Press
Time-Delayed Recording from the Menu
1. Ensure that TV Energy Mode is set to Fast Power On
TV Input
ANT 1, ANT 2
2. Press
3. Review the recording setup information. To change
IEEE 1394 devices
4. Specify when to start the recording.
ANT 1, ANT 2
INPUT 1-3,
COMPONENT 1
and 2
HDMI 1 and 2,
PC-DVI
5. Select Add and press ENTER to add the recording to
6. While the Recording Setup menu is displayed, press
7. From the Record List you can:
, CH
/ , or
Figure 2. Record List screen. From the Record menu,
press GUIDE to open the Record List to review or cancel
scheduled recordings.
• Record To. If you have more than one recordable
IEEE 1394 device connected, use
from the list in the Record To box.
• Duration. Use to select a recording dura-
tion of from 30 minutes to six hours in 30-minute
increments. The default is one hour.
a second time to start recording.
and the TV clock is set to the correct time and day.
See "Setup Menu" to make changes.
(RECORD) to open the Recording Setup menu.
the source, recording device, or duration, follow the
steps described above under "Recording Now."
• Start Time
a. With the hour highlighted in gold characters,
press to select the hour, including AM or
PM. Press ENTER to move the highlight to the
minutes.
b. With the minutes highlighted, press
select the minutes.
• Day. Use
to select a day of the week.
the Record List. A confirmation message will be
displayed if your selection is successful. If you pick
overlapping times, day(s), or destination devices, you
will see a message stating there is a conflict.
GUIDE to view a list of scheduled recordings and verify
the addition of the recording to the Record List, figure
2.
• Press GUIDE to return to the Recording Setup menu.
• Press EXIT to return to TV viewing,
to select it
to