Table of Contents
Advertisement
1.
Open the computer to the interactive position, as shown in the following illustrations.
2.
Release the WLAN antenna cables from the retention post (1) built into the top cover.
3.
Release the display panel cable from the retention post (2) built into the top cover.
4.
Remove the four Phillips PM2.5×4.1 screws (1) that secure the display assembly to the top cover.
5.
Slide the display assembly (2) forward until the display hinges (3) clear the top cover.
6.
Remove the display assembly (4).
Reverse this procedure to install the display assembly.
38
Chapter 5 Removal and replacement procedures
Hide quick links:
Advertisement
Table of Contents
