NOTE:
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
2.
Remove the Phillips PM2.0×2.7 screw (2) that secures the WLAN module to the top cover. (The WLAN
module tilts up.)
3.
Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
If the WLAN antenna cables are not connected to the terminals on the WLAN module, protective
sleeves should be installed on the antenna connectors, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
WLAN module
25