Introduction - Kohler 18TRES Installation Manual

This manual provides installation instructions for
Residential/Commercial model generator sets listed on
the front cover. Refer to TP-6515, Operation Manual, for
generator set operation and maintenance instructions.
The generator set is approved for use in stationary
applications in locations served by a reliable utility
power source.
Have an authorized distributor/dealer install the
generator set outdoors according to the instructions in
this manual. The generator set installation must comply
with the National Electrical Code (NEC) and local code
requirements. Do not install this generator set indoors.
1
15
1. Muffler
2. Oil check
3. Oil fill
4. Air cleaner
5. Fuses
6. RS-232 connector (for application program updates)
7. Controller user interface
8. Generator set master switch (RUN-OFF/RESET-AUTO)
9. Load circuit breaker
10. Field-connection terminal block location (RES models)
11. Spark plug locations (both sides)
12. Oil drain hose
13. Oil drain valve
Figure 1 Generator Set Component Locations, 8.5/12 kW Models
TP-6514 9/09
2 3 4 5 6
14 13 12 11
Information in this publication represents data available
at the time of print. Kohler Co. reserves the right to
change this publication and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual.
See Figure 1 and Figure 2 for generator set component
locations.
17
7
16
8
9
10
25
14. Oil filter
15. Exhaust
16. Equipment ground
17. Relay board location (optional)
18. Battery charger
19. DSAI lead location
20. Fuel block
21. Gas regulator assembly
22. Fuel solenoid valve
23. Fuel inlet
24. Air intake
25. Engine starting battery location (battery purchased separately)

Introduction

18 19 20 21
22
23
24
ADV-7466-
9