Table of Contents
Advertisement
7Interior
Designs
Adjustable
Features
Refrigerator
Shelves
The Tempered Glass Cantilever Shelves can be posi-
tioned to suit your individual needs. In some models, these
shelves are sealed to contain any spills which might occur.
To remove a shelf:
• slightly lift up the rear of the shelf
• pull the shelf straight out
To lock the shelf into another position:
• tilt up the front edge of the shelf
Slide-out shelves (certain models) can easily be pulled for-
, insert the hooks into the desired frame openings
ward for access to foods placed at the rear.
• let the shelf settle into place
To slide out:
• be sure the shelf is securely locked at the rear
• grasp the front of the shelf and pull forward
• push in the shelf to return to the original position
_k WARNING
-- Never attempt to adjust a shelf that is loaded with food (except in the case
of the Elevator
TM
Shelf).
ElevatoF _ Shelf
The fresh food compartment may be equipped with an
press both locks inwards.
Lift slightly and tilt the
Elevator
TM
Shelf. This shelf has a spill retainer edge for easy
frame assembly to allow the rear guides to clear the
cleanup. It also has the convenient slide out feature that allows
vertical rails.
easy access to items stored at the rear of the shelf.
• To reinstall, tilt the flame assembly while depressing
This shelf can be adjusted up or down without having to be
both locks, reposition the rear guide behind the verti-
unloaded of its contents.
To adjust an Elevator
TM
Shelf,
cal rails. When the shelf is level, release the locks
unfold the recessed crank handle so it is at a right angle to
allowing the shelf to latch in the correct position.
the shelf front. Crank to the right (clockwise) to raise the
height of the shelf, and the left (counterclockwise) to lower
the height of the shelf.
VERTICAL RAILS
To remove the Elevator
TM
shelf for occasional cleaning:
REARGUIDES
• Completely unload the shelf.
LOCKS
• Grasp the shelf front and pull forward until it stops.
• Press the stops from below (both sides) upward and con-
tinue pulling the shelf forward, clear of the frame.
• To reinstall, align the shelf to the frame and push it all
the way back. (There is no need to depress the stops for
FRAMEASSEMBLY
OUT SHELF
reinstallation).
In ordinary use, the Elevator
TM
shelf with the frame assem-
bly does NOT require removal. Though unlikely,
and not recommended, the correct removal procedure is as
follows:
• Unload the shelf completely.
• While supporting the shelf and frame from the front,
Advertisement
Table of Contents
