JVC KD-X330BTS Instruction Manual page 33

TROUBLESHOOTING
Symptom
No Bluetooth device is
detected.
Pairing cannot be made.
Echo or noise occurs.
Phone sound quality
is poor.
Sound is being
interrupted or skipped
during playback of a
Bluetooth audio player.
The connected Bluetooth
audio player cannot be
controlled.
JS_JVC_KD_X330BTS_X33MBS_K_EN_1.indd 29
Remedy
• Search from the Bluetooth device again.
• Reset the unit. ( 3)
• Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 14)
• Adjust the microphone unit's position. ( 14)
• Check the [ECHO CANCEL] setting. ( 16)
• Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
• Reduce the distance between the unit and the Bluetooth
audio player.
• Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to
the unit.
• Check whether the connected Bluetooth audio player
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
Symptom Remedy
"PAIRING FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 18, DELETE
PAIR)
"PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
"BT DEVICE NOT The unit failed to search for the registered Bluetooth
FOUND" devices during [AUTO CNNCT]. Turn on Bluetooth from
your device and connect manually. ( 18)
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"ERROR" Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
"H/W ERROR" Reset the unit and try the operation again. If "H/W ERROR"
appears again, consult your nearest service center.
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2 Reset the unit ( 3)
3 Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
29
ENGLISH
29/9/2015 3:55:42 PM