Upgrading Or Replacing Memory; Removing The Memory - HP Elite 7300 MT Servicing Manual

Upgrading or Replacing
Memory
Computer features may vary by model.
10 – 15 minutes
Before you begin
Observe the following requirements before removing
and replacing memory.
WARNING! Never open the cover with the power
applied. You might damage your computer or be
injured by the spinning the fan blades.
WARNING! Avoid touching sharp edge inside the
computer.
WARNING! Keep your hands away from the
moving fan.
WARNING! Keep fingers and tools clear of the
fan when the power is applied.
CAUTION: Static electricity can damage the
electronic components inside the computer. Discharge
static electricity by touching the metal cage of the
computer before touching any internal parts or
electronic components.
IMPORTANT: A memory card is extremely
sensitive to shock impact. Do not bang or drop it.
Static electricity can damage the card.
Tools Needed
Flathead/T15 Torx screwdriver
●
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
Memory Compatibility
Verify that the memory installed is compatible with
this computer. SO-DIMMs are small outline dual inline
memory modules. They are smaller and thinner than
14 Upgrading and Servicing Guide
most other DIMMs, so that they take less space in the
case. SO-DIMM modules must meet the following
requirements:
204-pin DDR3-DIMM
●
PC3-10600 (1333 MHz) DDR3-SDRAM
●
Unbuffered, non-ECC (64-bit) DIMMs
●
1.5 V memory only
●
16.0 GB maximum installable memory using
●
4GB Modules. Actual available memory that
can be used in Windows will be less.
Because the memory uses dual channels, you should
use the same DIMM type for both sockets.
NOTE: The actual memory transfer speed can vary
based on the CPU used in your computer.

Removing the memory

1.
Remove any media or storage devices such as
CDs, DVDs, and USB.
2.
Close all programs, and then shut down your
operating system.
3.
Unplug the computer by disconnecting the
power cord and all attached cables from the
back of the computer.
Features may vary by model.