HP ENVY x360 m6 Convertible Maintenance And Service Manual page 37

4. Pry the two screw covers from the middle of the bottom cover (3).
Rubber feet and rubber screw covers are available in the Rubber Kit, spare part number 807533-001.
5. Remove the 12 Phillips PM2.5×6.0 screws that secure the top cover to the computer.
6. Position the computer upright, and then open the computer as far as possible.
7. Starting on the inside above the keyboard near the hinges, pull up at the seams to disengage the cover
from the computer (1), far enough to access the keyboard and touchpad connectors on the system
board.
Component replacement procedures 27