Answering System Operation From A Remote Touch Tone Phone; Connect With The Answering System; Play Messages - AT&T 1760 User Manual

ANSWERING SYSTEM OPERATION
FROM A REMOTE TOUCH TONE PHONE

Connect with the Answering System

1 Dial your telephone number from a touch tone phone with a different telephone
number.
2 When the system answers, enter your three-digit Remote Access Code during or
after the announcement. The system announces the number of messages, then
beeps twice. If the announcement continues to play after you enter your code,
wait for the announcement to end, then re-enter the code
— OR —
Press # to stop the announcement, then re-enter the code.
3 The two-beep signal lets you know the system is ready to accept a remote
command.

Play Messages

1 Connect with the answering system.
2 After the two beeps, wait four seconds, and the system plays back messages
— OR —
Press 1 to play all messages
— OR —
Press 2 to play only new messages (if there are no new messages, the system
announces,"No new messages").
3 To repeat a message — Press 4 while the message is playing.
To repeat part of a message — Hold down 4. To resume playing, release 4.
To skip a message — Press 6 while the message is playing.
To skip part of a message — Hold down 6. To resume playing, release 6.
To stop message playback — Press 5.
To save messages, hang up.
18