Denon DN-501C Owner's Manual page 50

n Remote Control Connection
• Connection Example
Normal Mode
MODE2 MODE1
6 Search 7
STOP EOM
FADER
START
It is assumed that the input pins and Tally output pins are used as follows.
入力ピン
Input pin
(23pin)
IN
GND
最大
Maximum
10ｍA
10 mA
Skip back
CUE Playback pause Playback
TRACK (–) TRACK (+)
Tally出力ピン
Tally output pin
(22pin)
IN
VCC
Hot Start Mode
Hot Cue Mode
MODE2 MODE1 CUE
RELOAD Hot Hot
Start 1 Start 2 Start 3
Hot Hot Hot
Start 6 Start 7 Start 8
• Tally output pin is an open collector. (Maximum current: 10 mA, maximum voltage; 5.5 V)
• Input pin is 5 V for Vcc TTL specification.
• The maximum current supplied by the Tally Power Supply (22 pin) is 100 mA.
• The input/output logic is active low (negative logic).
NOTE
Power is supplied to the external remote controller from Pin No.22 (Tally Power Supply) from this terminal.
However, as the maximum rating for this pin is +5 VDC 100 mA, select circuit and current controls
(resistance values) so as not to exceed the rating. Using this equipment when the rated value is exceeded
may cause damage to the equipment, which may also lead to fire or a similar unexpected accident.
44 44
Playback pause Playback
Hot Hot Hot
Start 4 Start 5
Hot Hot
Start 9 Start 10
Parallel Control