Denon DN-501C Owner's Manual page 22

Item Setting Details (Items in bold are factory default)
Skip Back 0.5 to 2 to 60 sec: Set the skip back time for a track that is currently being
played back to 0.5 second intervals between 0.5 and 10
seconds, or 5 second intervals between 10 and 60 seconds.
Normal: Plays back audio in 2 x speed search, but does not play back audio at
Search Mode
Sets the search mode. faster playback speeds.
Silent: Audio is not played back during search.
Auto Fade In Off: Does not function.
Sets fade in. 0.5 sec: Sets the volume to gradually increase within 0.5 seconds.
1.0 sec: Sets the volume to gradually increase within 1 seconds.
3.0 sec: Sets the volume to gradually increase within 3 seconds.
Auto Fade Out Off: Does not function.
Sets fade out. 0.5 sec: Sets the volume to gradually decrease within 0.5 seconds.
1.0 sec: Sets the volume to gradually decrease within 1 seconds.
3.0 sec: Sets the volume to gradually decrease within 3 seconds.
Start Delay Off: Does not function. (Playback starts immediately).
Sets the playback start 100 ms: Playback starts after a 0.1 second gap.
timing. 200 ms: Playback starts after a 0.2 second gap.
300 ms: Playback starts after a 0.3 second gap.
End Of Message Off: Does not function.
Sets how the EOM 0 sec: EOM display flashes for 0.5 seconds after the track finishes.
display lights in the 5 sec: EOM display flashes from 5 seconds before the track finishes.
display. 10 sec: EOM display flashes from 10 seconds before the track finishes.
15 sec: EOM display flashes from 15 seconds before the track finishes.
20 sec: EOM display flashes from 20 seconds before the track finishes.
30 sec: EOM display flashes from 30 seconds before the track finishes.
60 sec: EOM display flashes from 60 seconds before the track finishes.
Next Trk Reserve Off: Playback of the selected track starts immediately.
Reserving the next On: When the track is selected, when currently track is stopped playback or
ENTER
track to playback during button is pressed, then playback the selected track (reserved track).
playback.
Off: Disables the tone control for the pitch control function.
Master Key
On: Enables the tone control for the pitch control function.
Off: Does not function.
End Monitor
Plays the specified 5sec: Playback starts from 5 seconds before the end of the track.
amount of time at the 10sec: Playback starts from 10 seconds before the end of the track.
end of a track. 15sec: Playback starts from 15 seconds before the end of the track.
20sec: Playback starts from 20 seconds before the end of the track.
25sec: Playback starts from 25 seconds before the end of the track.
30sec: Playback starts from 30 seconds before the end of the track.
35sec: Playback starts from 35 seconds before the end of the track.
Item Setting Details (Items in bold are factory default)
Dimmer Off: Disables the "Dimmer" settings.
Enables/disables the On: Enables the "Display Dimmer" and "LED Dimmer" settings.
"Display Dimmer"
and "LED Dimmer"
settings.
Display Dimmer 100 %: Normal brightness.
Sets the brightness of 75 %: 75 % of the normal brightness.
the display. 50 %: 50 % of the normal brightness.
(Enabled when the 25 %: 25 % of the normal brightness.
"Dimmer" setting is 0 %: Off in the standby status, and 25 % of the normal brightness during
On. ) operation.
LED Dimmer 100 %: Normal brightness.
Sets the LED 75 %: 75 % of the normal brightness.
brightness. 50 %: 50 % of the normal brightness.
(Enabled when the 25 %: 25 % of the normal brightness.
"Dimmer" setting is
On. )
Screen Saver Off: Does not function.
Sets the screen saver On: The screen saver starts when there are no operations for 30 minutes.
operation.
Track: Displays the remaining time for each track.
Remain Time Mode
Sets the remaining Total: Displays the remaining time for all playback target tracks (CDDA only).
time display.
Fader Start Play: Plays back while the FADER START pin of the parallel remote is closed.
Sets the operations Play-Pause: Plays back while the FADER START pin is closed, and pauses
when parallel remote when this pin is opened.
is used. Play-Next: Plays back while the FADER START pin is closed, and jumps to the
next track when this pin is opened.
Play&Lock: Plays back while the FADER START pin is closed, and locks the
keys of the unit.
Play&Lock-Pause: Plays back when the FADER START pin closes, and locks
Play&Lock-Next: Plays back when the FADER START pin closes, and locks the
Hot Start: Sets the Hot Start mode.
Para Rem Mode
Sets the operation Hot Cue: Sets the Hot Cue mode (Playback is not performed by Hot Start).
when Hot Start
playback.
Default Resets all of the preset settings to the defaults.
16 16
Setting Defaults
the keys of the unit. Playback pauses when this pin opens.
keys of the unit. Playback jumps to the next track when this
pin opens.