Table of Contents
Advertisement
4-8. Air-Cooled Feeder Connections
2
Rear Panel
Connect To
Positive (+) Weld
Output Terminal On
Welding Power Source
4
6
7
4
1
5
Connect To
Regulator/
Flowmeter
3
7
8
Top View
Tools Needed:
5/8, 1-1/8 in
1
Gas Hose Grommet
2
10 ft (3 m) Gas Hose
3
Rear Of Gas Fitting
Route one end of gas hose through
grommet, and connect hose to rear
of Gas fitting in feeder. Connect
remaining
end
of
hose
regulator/flowmeter .
4
Weld Cable To Welding Power
Source
Select and prepare weld cable ac-
cording to welding power source
manual.
5
Weld Cable Grommet
6
Current Sensing (Reed) Relay
7
Weld Cable Terminal In
Feeder
Route one end of weld cable
through grommet, through reed
relay, and connect to weld cable
terminal
in
feeder.
Connect
remaining end of cable to positive
(+) weld output terminal on welding
power source.
8
Gun Weld Cable
Be sure that terminal of welding
power source weld cable is in direct
contact with terminal from gun weld
cable. Close and latch door.
Ref. 151 771-A
OM-1581 Page 15
to
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
