GE PGP9830 Owner's Manual & Installation Instructions page 16

o_
O
.._hal
O
O
U
Or)
or)
E_
LO
(D
t--
Oh
t--
r---
E3
(b
U
G
Z
!
Z
<I:
,,,,J
!,3
a
Z
<1:
I,,IJ
rY
<1:
Ij
Cleaning the Glass Cooktop
Heavy, Burned-On Residue
I. Allow the cooktop to cool.
2. Remove the burner grates, vent grille and vent grille
gasket.
3. Use a single-edge razor blade scraper at approximately
a 45 ° angle against the glass surface and scrape the
soil. It will be necessary to apply pressure to the razor
scraper in order to remove the residue.
4. After scraping with the razor scraper, spread a few drops
of CERAMA BRYTE ® Ceramic Cooktop Cleaner on the
entire burned residue area. Use the CERAMA BRYTE ®
Cleaning Pad to remove any remaining residue.
5. For additional protection, after all residue has been
removed, polish the entire surface with CERAMA
BRYTE ® Ceramic Cooktop Cleaner and a paper towel.
The CERAIV]A BRYTE ®Ceramic Cooktop Scraper and all recommended
supplies are available through our Parts Center. See Assistance / Parts
And Accessories section.
NOTE: Do not use a dull or nicked blade.
Metal Marks and Scratches
Be careful not to slide pots and pans across your cooktop.
It will leave metal markings on the cooktop surface.
These marks are removable using the CERAMA BRYTE ®
Ceramic Cooktop Cleaner with the CERAMA BRYTE ®
Cleaning Pad for Ceramic Cooktops.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your
cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when
removing hot substances.
Be sure to use a new, sharp razor scraper.
Do not use a dull or nicked blade.
1. Turn off all surface burners and, with an oven mitt,
remove hot pans and grates.
2. Wearing an oven mitt:
a. Use a single-edge razor blade scraper
(CERAMA BRYTE ® Ceramic Cooktop Scraper) to
move the spill to a cool area on the cooktop.
b. Remove the spill with paper towels.
3. Any remaining spillover should be left until the surface
of the cooktop has cooled.
4. Don't use the surface units again until all of the
residue has been completely removed.
NOTE: If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.
16 49 80516 4