Installing And Threading Welding Wire - Miller Electric S-22P12 Ultra-Lite Owner's Manual

3-8. Installing And Threading Welding Wire

Install wire spool.
Adjust tension screw so wire is taut
when wire feed stops.
Lay gun cable out straight.
Open pressure assembly, hold wire
tightly, and cut off end. Push wire
through guides into gun.
Close and tighten pressure assem-
bly. Press JOG button until wire
comes out gun.
To adjust drive roll pressure, press
gun trigger to feed wire against
wood surface. Tighten knob so wire
does not slip.
Cut off wire. Close door.
Tighten
WOOD
Tools Needed:
9/16 in
ST-156 377-B / Ref. ST-159 048-A / S-0627-A
OM-181 931 Page 14