Dealer Check List - Woods FZ25D Operator's Manual

PRE-DELIVERY CHECK LIST
(DEALER'S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to
make sure it is set up properly before delivering it to the
customer. The following check list is a reminder of
points to inspect. Check off each item as it is found sat-
isfactory, corrections are made, or services are per-
formed.
___ Check that all safety decals are installed and in
good condition. Replace if damaged.
___ Check that all shields and guards are properly
installed and in good condition. Replace if dam-
aged.
___ Properly attach implement to power unit and
make all necessary adjustments.
___ Check all bolts to be sure they are properly
torqued.
___ Check that all cotter pins and safety pins are
properly installed. Replace if damaged.
___ Check and grease all lubrication points.
___ Check the level of gearbox fluids before delivery.
___ Run unit immediately following set-up to double-
check systems operation including hydrostatic
neutral and safety switch system (page 12).
___ Check all fluid levels. See Owner Service section.
MAN0646 (Rev. 11/5/2007)
DEALER CHECK LISTS
Dealer Check Lists 29
___ Check tire pressure. See Assembly section.
DELIVERY CHECK LIST
(DEALER'S RESPONSIBILITY)
___ Show customer how to make adjustments.
___ Instruct customer how to lubricate and explain
importance of lubrication.
___ Point out the safety decals. Explain their meaning
and the need to keep them in place and in good
condition. Emphasize the increased safety haz-
ards when instructions are not followed.
___ Present Operator's Manual and request that cus-
tomer and all operators read it before operating
equipment. Point out the manual safety rules,
explain their meanings, and emphasize the
increased safety hazards that exist when safety
rules are not followed.
___ Show customer how to make sure driveline is
properly installed and that spring-activated lock-
ing pin or collar slides freely and is seated in
groove on power unit PTO shaft.
___ Show customer the safe, proper procedures to be
used when mounting, dismounting, and storing
equipment.
___ Make customer aware of optional equipment
available so that customer can make proper
choices as required.
❖