Airstream 1980 Argosy Owner's Manual page 70

Tape Deck Operation (Cassette)
With select switch in TAPE position, the player
is automatically turned on when the cassette is
inserted and seated. To insert cassette, hold
cassette with exposed tape surface facing
right, and place cassette into slot. Then guide it
in gently with fingers until cassette snaps into
place. Cassette will now play continuously until
ejected. Each cassette has two program tracks
(side one and side two). To change from one
track to the other, momentarily depress the
Program change button. If allowed to play
continuously the player will automatically
reverse at the end of the program and play the
second track.
To eject the cassette, depress "EJECT"
button. The cassette will protrude for easy
removal.
An illuminated arrow will appear to the right of
the toggle lever when playing tapes. The
arrows indicate the forward or reverse direction
of the tape and which track is playing. If the
cassette has been inserted with Side One
upwards and the right arrow lights, this
indicates that the program on Side One is
playing. Depressing the Program change
button will cause the left arrow to illuminate and
will mean Side Two is playing. These arrows
also indicate in which direction the toggle lever
should be moved in order to move the tape
Fast Forward or Rewind.
FAST FORWARD
. .
.
To rapidly advance tape
(Fast Forward) to another portion of the
program, press the toggle lever in the direction
of the illuminated arrow. The lever will lock and
remain in this position until you return it to the
center position. The unit will then begin playing
the tape at its advanced position. If end of tape
is reached while in the Fast Forward mode, the
lever will automatically return to the center
position and the tape unit will begin playing the
start of the 2nd program track.
FAST REVERSE . . . To rapidly rewind tape
(Fast Reverse) in order to repeat the program
material, press the toggle lever in the direction
opposite to the direction indicated by the
illuminated arrow. Returning the lever to the
center position will again place the tape in the
playing mode and the recorded program will
repeat. If the start of the tape is reached, the
lever will automatically return to center position
and the entire program will repeat.
Store tapes and cassettes in a cool area with
open end down. Protect tapes from dust and
direct sunlight.
In time, oxide from recording tape will
accumulate on the tape head and capstan
shaft which can cause tape hiss and erratic
operation. The more often the player is used,
the more often it should be cleaned.
Clean the head with a cotton swab moistened
with isopropyl alcohol. Do not use carbon
tetrachloride.
To clean the capstan shaft, first turn on the
motor by depressing the motor switch (next to
or in front of the capstan shaft) wlth the eraser
end of a pencil. Use a cotton swab moistened
with alcohol on the shaft.
The fuse for the radio, or radio/tape is located
behind the unit. To gain access to the fuse,
carefully pry off the metalized plastic front
bezel of radio unit. Remove four attaching
screws and slide unit out.
The Armstrong or Coleman air conditioner
can be used for cooling or heating (heat strip
optional on some models) your trailer or for air
circulation only.
Operating Instructions
-
Armstrong:
To operate for cooling:
1 . Make sure you are connected to 120V AC
supply. Close doors, windows and
ventilators.
2. Set thermostat to "COOL" position and
set thermostat indicator to your desired
comfort level.
3. Set system switch (located at ceiling cover
of air conditioner) to your preferred speed
setting.
Note: The air conditioner w~ll not operate
until speed selection is made. The
recommended cooling speeds for various
outdoor temperature ranges are:
tli-Cool
Med-Cool
Lo-Cool