Airstream 1980 Argosy Owner's Manual page 69

F I ~
1
-
Electron~c D ~ g ~ t a l Clock
Optional Motorola AM-FM Stereo Radio
and Combination Motorola Stereo AM-FM
Radio with 8 Track Stereo Tape Player
Operating Instructions
1 . Switch power on by pressing POWER
button to "in" position. Switch power off
by pressing POWER button again,
releasing it to "out" position.
2. Turn SELECT control to desired mode of
operation (AM, FM, FM STEREO, FMLC,
or TAPE) NOTE: FMLC position is useful
only in strong FM signal areas, especially
where many FM stations may tend to
interfere with each other. FMLC position
minimizes this type of interference. For
best FM reception under normal conditions
the "FM STEREO" position should be
used. The "FM" position is useful in fringe
areas to lock receiver into monaural mode,
thus eliminating stereo threshold noise.
3. Turn TUNING control to select desired
station.
4. VOLUME . . . Turn VOLUME control to
right to increase volume and left to
decrease volume.
5. BALANCE (Left-to-right)
. . .
Turn
BALANCE control either right or left as
required for desired left and right sound
level.
6. FADER (Front-to-Rear)
. . .
Turn FADER
control either right or left as requied for
desired front and rear sound level.
,
7. BASS
. . .
Turn BASS control either right or
left as required for desired bass response.
8. TREBLE . . . Turn TREBLE control either
right or left as required for desired treble
response.
9. NOISE FILTER
. .
.
Press NOISE FILTER
button to "in" position to reduce annoying
noise during reception.
10. STEREO INDICATOR LIGHT (FM STEREO
ONLY)
. . .
The indicator light will go on
automatically when selected FM station is
broadcasting Stereo. The light is not on
when monaural broadcasts are being
received, or when a stereo signal drops
below a predetermined level. The radio is
designed to reproduce weak stereo signals
monaurally to provide more noise free
reception. When the signal increases
beyond the threshold level, the stereo
indicator will light again.
Tape Deck Operation (8 Track)
Insert tape cartridge into slot (behind hinged
panel, see Fig. 2) to a fully seated position to
switch tape deck on. Receiver SELECT switch
must be in TAPE position to operate tape deck.
Fig 2
-
Stereo Tape and A M / F M R a d ~ o
Retracting tape cartridge approximately one
inch from seated position or removing tape
cartridge completely switches tape deck off.
The program indicator lights indicate which
tape program is playing.
When REPEAT botton is in "IN" position, the
tape deck will continue playing the same
program that is playing until another program is
selected or button
IS
released to "OUT"
position.
Press and release PROGRAM button to
position tape deck pick-up head to the next
program on the tape. NOTE: If PROGRAM
selector feature is not used the four programs
will play in sequence except when "REPEAT"
button is in "REPEAT" position. The tape deck
will play contir~uously in this manner until tape
cartridge is pulled out from its seated position.