Airstream 1980 Argosy Owner's Manual page 65

Flg 7
-
Lounge Into Bed
To convert the lounge into a bed, grasp the
front edge of the seat, (See Fig. 1
),
lift up
slightly and pull lounge assembly out until it
stops and the lounge back is in a horizontal
positon. (See Fig. 2). Place bolster filler strip In
position between lounge back and trailer wall
(See Fig. 3) (not necessary with 5th Avenue
Lounge).
To return bed to lounge position, remove
bolster strip, push lounge back toward wall
until seat back is in upright position. Pull seat
back forward to provide access, and store
bolster strip behind.
An optional space locker attached to the roof
lockers is available for additional storage space
for bedding, etc. in the bedroom.
All the cabinet drawers are removable allowing
you storage flexibility and ease of packing and
unpacking. Wardrobe catches are self-locking.
When attaching wall hung improvements, like
hooks for clothing, bookshelves and extra
towel racks, secure with half-inch No. 8 sheet
metal screws @bW wi.th flat binder heads,
make holes in the aluminum inner walls with a
small drill bit (No. 30).
The bunk beds (optional), located in the
bedroom, serve as the back bolster for the bed
when not in use. In order to place bunk into
sleeping position:
1 . Depress latch located on the center back
side of the bolster.
2. With latch depressed pull on on fabric loop
located on the center front bottom of
bolster. This will allow bolster filler to hinge
down.
3. Bring bolster filler up to horizontal position
and attach both straps to bracket on ceiling.
To lower bunk:
1
.
Release straps.
2. Rotate bolster filler into latched position
3. Lower bolster down against wall.
Make beds in the usual way, using fitted sheets
3 / 4 bed size.
To make fixed twin beds, lift mattress slightly,
pull it away from the wall and then tuck
bedding along wall.