Servicing Fuel And Lubrication Systems (Deutz F4L2011-Powered Units) - Miller Electric Big Blue 500D Owner's Manual

9-7. Servicing Fuel And Lubrication Systems (Deutz F4L2011-Powered Units)

!
Stop engine and let cool.
!
After servicing, start engine and
check for fuel leaks. Stop engine,
tighten connections as necessary,
and wipe up spilled fuel.
1 Oil Filter
2 Oil Drain Valve And Hose
3 Oil Fill Cap
4 Primary Fuel Filter (Fuel/Water Sepa-
rator)
5 Petcock
6 Secondary Fuel Filter
7 Fuel Tank Sludge Drain Valve
To change oil and filter:
Route oil drain hose and valve through hole
in base. See engine manual and engine
OM-4428 Page 48
1
maintenance label for oil/filter change in-
formation.
To drain water from fuel system:
Open primary fuel filter petcock and drain
water into metal container. Close petcock
when water-free fuel flows.
To replace primary fuel filter:
Turn filter counterclockwise. Remove filter.
Apply thin coat of fuel to gasket on new filter.
Fill filter with fuel. Install filter and turn clock-
wise. Bleed air from fuel system according
to engine manual.
Inspect fuel line, and replace if cracked or
worn.
3
4
5
6
2
7
To replace secondary fuel filter:
See engine manual.
Close doors.
To drain sludge from fuel tank:
!
Beware of fire. Do not smoke and
keep sparks and flames away from
drained fuel. Dispose of drained fuel
in an environmentally-safe manner.
Do not leave unit unattended while
draining fuel tank.
!
Properly lift unit and secure in a level
position. Use adequate blocks or
stands to support unit while drain-
ing fuel tank.
Attach 1/2 ID hose to drain valve. Put metal
container under drain, and use screwdriver
to open sludge drain valve. Close valve
when sludge has drained. Remove hose.
Tools Needed:
803 657