Equipment Connection Diagram - Miller Electric SuitCase X-TREME 12VS Owner's Manual

4-3. Equipment Connection Diagram

1
2
3
4
5
Notes
10
9
8
7
6
!
Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
!
Use only with CC/CV DC
Power Sources.
1 Constant Current (CC) or
Constant Voltage (CV)
Welding Power Supply
2 Weld Cable To Feeder
3 Ground Cable To Workpiece
Weld cable and ground cable con-
nections to power source (DCEN/
DCEP) are dependant on wire type.
.
Since feeder is not polarity sen-
sitive, there is no need for an
electrode polarity switch.
4 Workpiece
5 Voltage Sensing Clamp
Connect voltage sensing clamp to
workpiece.
6 Gun
7 Gun Trigger Receptacle
8 Wire Feeder
9 Gas Hose
10 Gas Cylinder
Use of shielding gas is dependant
on wire type.
.
Shielding gas pressure not to
exceed 100 psi (689 kPa).
Ref. 804 000-C
OM-1500-19 Page 15